The Wall
Forum / THE MAIN WALL / Can you tell me what kind/brand of Pex this is?
  • Post a Reply to this Thread

    Can you tell me what kind/brand of Pex this is? (9 Posts)

  • knotgrumpy knotgrumpy @ 2:12 PM
    Contact this user

    Can you tell me what kind/brand of Pex this is?

    I tried asking the question on John's Blog on Taco's site, but Wordpress doesn't seem to be sending out log-in passwords there.

    Anyway - who makes the red Pex in this picture:

    http://jbblog.flopro.taco-hvac.com/wp-content/uploads/2013/02/eric-ZV1.jpg

    Thanks,

    Mark
  • JStar JStar @ 2:32 PM
    Contact this user

    Pex

    Rifeng?
    - Joe Starosielec
    http://thatcherhvac
    http://facebook.com/thatcherhvac



    Guaranteed performance. Guaranteed energy savings.


    Serving all of NJ, NYC, Southern NY State, and eastern PA.

    Consultation anywhere.

    (Formerly "ecuacool")
  • Zman Zman @ 2:42 PM
    Contact this user

    Pex b

    It looks like pex b.Is their any writing?
    Carl
  • Ironman Ironman @ 3:25 PM
    Contact this user

    Eric Aune

    That's Eric in the pic. Why not send him a p/m and see if he remembers?
    Bob Boan



    You can choose to do what you want, but you cannot choose the consequences.
  • knotgrumpy knotgrumpy @ 5:16 PM
    Contact this user

    Thanks to all

     "That's Eric in the pic. Why not send him a p/m and see if he remembers? "

    Thanks Bob, I did just that.

    Mark
  • pipeking pipeking @ 3:49 PM
    Contact this user

    looks like

    BOW heatpex. my supplier has a heatpex with a red oxy barrier Made by BOW.
  • EricAune EricAune @ 5:25 PM
    Contact this user

    PEX

    The PEX pictured is MrPEX brand barrier tubing. This was the first time I used it. I like it a lot, very flexible and easy to work with. The 3/4" lines run to remote manifolds for either towel warming, in-floor or panel rads. I have used miles of Fosta PEX but the budget didn't allow for it here. I have used it many times since, solid company and great service.
    "If you don't like change, your going to like irrelevance even less"
    This post was edited by an admin on February 22, 2013 5:26 PM.
  • knotgrumpy knotgrumpy @ 8:17 PM
    Contact this user

    Thanks Eric!

    Their tubing is made in the Netherlands if I remember right.  LK maybe?

    Do you order it directly from them?

    Mark
  • Solid_Fuel_Man Solid_Fuel_Man @ 6:56 PM
    Contact this user

    Mr.Pex

    is made in Sweden, at least the barrier type is.  I like it a lot, basically same to work with as Uponor.  My supplier sells it in 1,000 foot boxes, the uncoil-er is nice if you have a lot to do.  It's my favorite for slabs and the tight bends for 6" O.C.
    Always keep learning: observing what works, and what doesn't. Ask questions
    This post was edited by an admin on February 23, 2013 6:57 PM.
  •  
Post a Reply to this Thread