This thread has been bookmarked. Visit your bookmarked threads to review.
Post a Reply to this Thread
QUESTION FOR THE MONTH (6 Posts)
N/A April 20, 2013 @ 3:34 PM
QUESTION FOR THE MONTHAll welcome to try except Eugene.
Scenario, two houses side by side, both have been with out power for 2 days.Outdoor temperature 115F 90%rh. Inside temperature 98F 90%fh. Both house lost a compressor, both three ton scroll, house- a runs on r-22 house- b runs on 410a. Both systems use a fixed orFice on the indoor coil. Service company A arriVeS at house-a at 10:00 am to replace compressors. Service company B arrives 5 minutes later to house B to replace compressor. Service company A finishes, collects and leaves at 2:30 p.m. Service Company B finishes, collects and leaves at 9:30 pm. why so long.
PEACE NE WITH YOU
DAVID C. BROOME
CompressorsI bet the company working on the system with R410A had a heck of a time charging their unit. Maybe they installed a second compressor as well?- Joe Starosielec
Guaranteed performance. Guaranteed energy savings.
Serving all of NJ, NYC, Southern NY State, and eastern PA.
(Formerly "ecuacool")This post was edited by an admin on April 20, 2013 7:55 PM.
A/CHouse "A" had a service contract and paid a flat fee. House "B" called someone from the yellow pages, and paid time and materials?
Oh c'monno AC talk yet, its still 30 at night over here... 410a doesn't like high ambients, but recovering, then holding, then flushing the system, and changing the txv, compressor, ect , then nitrogen testing, then vacc-ing it down, then charging it, it takes a lot of time... I have done my share, none of them are fun, although we dont normally get 115* ambients around here... maybe 98* but not very often... I can count on one hand how many triple digit days we have had in my memory..This post was edited by an admin on April 20, 2013 9:37 PM.
N/A April 20, 2013 @ 11:15 PM
come on fellas not rocket sciencedo you eed a hint
FreonMoisture. It's harder to pull moisture out of a 410a system. If left open to long it is harder to get down to an acceptable micron reading.