The Wall
Forum / THE MAIN WALL / Introducing the New
  • Post a Reply to this Thread

    Introducing the New (8 Posts)

  • Chris Chris @ 6:37 PM
    Contact this user

    Introducing the New

    Peerless WB90 now available. Attached are the lit and install manual for your reading. Uses Pellet Boiler Venting. If my fellow friends are interested I do have the list price sheet but will only send to guys I know are in the trade.
    "The bitter taste of a poor installation remains much longer than the sweet taste of the lowest price."
  • Robert O'Brien Robert O'Brien @ 7:23 PM
    Contact this user

    Price

    I'm curious
  • Chris Chris @ 8:25 PM
    Contact this user

    Check Your Email

    Sent it over to you.
    "The bitter taste of a poor installation remains much longer than the sweet taste of the lowest price."
  • Ron Jr. Ron Jr. @ 8:48 PM
    Contact this user

    A 90 % pin boiler ?

    What will the triple pass snobs say about this ! :)

    My favorite oil boiler just got better . No coil port though ...... 
  • R Mannino R Mannino @ 9:31 PM
    Contact this user

    You Can Call Me

    Thurston Howell III you dirty dog you, that's why there's no coil port!

    I would however be curious to cut and slide it at your house and see some real world performance numbers. :-)

    Ron
  • Ron Jr. Ron Jr. @ 10:22 PM
    Contact this user

    Just kidding

    about snobbery !  I wonder if they sell a conversion kit for the countless thousands of WBV blocks out there already . And I wonder if the AFUE would go up if you kept the burner on low fire permanently ....... 
  • James Day James Day @ 9:09 PM
    Contact this user

    price

    I'm intrigued on the pricing.  
    James
  • SWEI SWEI @ 11:22 PM
    Contact this user

    nice work

    and shows there's still some life left even in the older CI block designs.

    The gains in both comfort and efficiency when going from single to two-stage burners can be impressive.

    Now, if Carlin would just offer a two stage version of the EZ-Gas...
  •  
Post a Reply to this Thread