The Wall
Forum / THE MAIN WALL / More on Power Gas Burner Conversions
  • Post a Reply to this Thread

    More on Power Gas Burner Conversions (5 Posts)

  • Tim McElwain Tim McElwain @ 1:24 PM
    Contact this user

    More on Power Gas Burner Conversions

    What do you think about boiler manufacturers taking existing design oil steam and forced hot water boilers and factory installing gas power conversion burners in them testing them and and selling them?
  • SWEI SWEI @ 4:41 PM
    Contact this user

    OK

    Where do we sign up?
  • MarkS MarkS @ 5:38 PM
    Contact this user

    Yes

    Given the level of interest in power gas burners you'd think more boiler manufacturers would have done this by now.
    Homeowner, Royersford PA | 1890 one-pipe steam system | 3009 sf | 3 floors | 14 radiators | Utica SFE5200S boiler
    NEW Midco LNB-250 Modulating Gas Burner | EcoSteam modulating controls | 70 to 300 MBH |
    607 sf EDR connected load | Operating pressure: 0.5 oz/in2
    Four main runs (insulated) totaling 135 ft in length | All Gorton vents on mains & rads |
    A Steam Odyssey | Odyssey 2 | A Steam Enthusiast's Outdoor Reset Control
  • Steamhead Steamhead @ 8:14 PM
    Contact this user

    Bring 'em on!

    Hey Burnham- are you listening? We want a gas MegaSteam!
    "Reducing our country's energy consumption, one system at a time"

    Steam, Vapor & Hot-Water Heating Specialists

    Oil & Gas Burner Service

    Baltimore, MD (USA) and consulting anywhere.
  • SWEI SWEI @ 8:24 PM
    Contact this user

    Every mod/con boiler

    is based around a low-NOx modulating power gas burner.  Midco obviously noticed this, and there are a number of large burner manufacturers using similar designs (they may well have been first for all I know.)
  •  
Post a Reply to this Thread