Joined on November 16, 2012
Last Post on September 16, 2014
@ September 16, 2014 3:04 PM in solo 250My triangle tube solo 250 goes into no flame ignition regular replaced the ignition cable did a combustion test checked gas pressure have about a 1.5 inch drop what could be my problem
@ March 11, 2014 10:51 AM in Mono Flow IssuesWhere can you read or find that info on monflow. HAVE 4 350000 BTU Systems that were put in about 1984 that never really worked real great from day 1
@ March 7, 2014 9:26 AM in Completed boiler & chiller instaland they say there is no good help left. BEAUTIFUL
@ February 28, 2014 9:32 AM in PEX SYSTEMWhat is the preferred pex system. If someone wanted to use only one system . Meaning ease of installation.Or user friendly.To work with.
@ February 27, 2014 2:17 PM in PEX SYSTEMWhat is the preferred pex system. If someone wanted to use only one system . Meaning ease of installation.Or user friendly.To work with
@ February 27, 2014 2:16 PM in pex systemWhat is the preferred pex system. If someone wanted to use only one system . Meaning ease of installation.Or user friendly.To work with.
@ February 24, 2014 5:20 PM in friction lossI need 50 gpm. IF I COULD GET 60 I PROBABLY WOULD TAKE IT.
@ February 19, 2014 1:12 PM in friction lossI am wondering how much friction loss i have i my heating system.
710' of 2'' pipe
2 2" 45 degree elbows
21 2" 90 degree elbows
and then i have 3 2" close return bends where the water makes a 180 degree turn
@ December 24, 2013 6:21 PM in Superstor contender piping ?what kind of indirect do you have my understanding is with a TT that is the way you pipe it
@ December 9, 2013 9:36 AM in Old raypackI have a old raypack boiler that tends to burn out the front .What can causes that . I am thinking it is a draft issue . Can a bent vent cap cause that . wind is blowing.
@ November 8, 2013 11:22 AM in Drain Stopper LeakI would replace the sink drain and the piece rite below the drain it is a plastic nut and a nylon gasket in there that to me seems to also be your problem. make sure you get the gasket that adapts to 1.25 instead to 1.5.
Did you put some kind of drain cleaner in there some products will heat up where they can melt that plastic.if you put in to much. good luck
@ November 7, 2013 12:08 PM in Knight boiler problemsHad a problem on a 399 .Called tech support they told me to replace the fan. So i played with it a little bit it seamed like the fan was partly ceased . Took it apart and replaced a bearing in the fan housing. I picked up for like a buck .Put it back together . Have not had a problem sense . I own the boiler. .
@ July 26, 2013 4:49 PM in I was all set to order my boiler...right now who has the best all around design
@ July 26, 2013 9:53 AM in I was all set to order my boiler...robert 10 years ahead in what
@ July 6, 2013 7:10 PM in Lochinvar WHN vs Crest vs othersI own them both. I think the lochinvar is built a little better . But TT sems easier to work on.
@ June 5, 2013 10:08 AM in Buy Americanhttp://www.ellinghuysen.com/news/articles/145379.shtml